Institute of Fundamental Technological Research
Polish Academy of Sciences

Partners

Mariusz Kulczyk


Recent publications
1.  Skorupska M., Kulczyk M., Denis P., Grzęda D., Czajka A., Ryszkowska J., Structural Hierarchy of PA6 Macromolecules after Hydrostatic Extrusion, Materials, ISSN: 1996-1944, DOI: 10.3390/ma16093435, Vol.16, No.9, pp.1-18, 2023

Abstract:
This article presents the influence of severe plastic deformation by hydrostatic extrusion (HE) on the thermal and structural properties of polyamide 6 (PA6). During the hydrostatic extrusion process, a fibrous structure oriented along the extrusion direction is formed, which was visualized during microscopic observations. The degree of crystallinity was analyzed by differential scanning calorimetry (DSC). Wide-angle X-ray scattering diffraction (WAXS) analysis was used to partially characterize the PA6 structure after the HE process. The contents of various forms of the crystalline phase in PA6 samples before and after the HE process were analyzed in fragments of spectroscopy in infrared (FTIR). The favorable properties of PA6 after the HE process were obtained after deformation under conditions generating an adiabatic temperature higher than the glass transition temperature and lower than the temperature of the onset of melting of the crystalline phase. Thermal analysis using DSC allowed us to conclude that in the PA6 after the HE process generating deformations in the range of 0.68–1.56, the proportion of the crystalline phase α increases in PA6. As the deformation increases in the HE process, the crystalline phase proportion increases by 12% compared to the initial material (before HE). The glass transition temperature of PA6 is ca. 50.6 °C, reduced for the sample after the HE process at a small deformation of 0.68 (PA6_0.68) to ca. 44.2 °C. For other samples, Tg is ca. 53.2–53.5 °C. As a result of the analysis of WAXS diffractograms of PA6 samples after various deformations in the HE process, the presence of typical peaks of phases α1 and α2 and γ was observed. The results of the FTIR spectroscopic analysis confirm these observations that as the deformation increases, the proportion of the crystalline phase α increases.

Keywords:
hydrostatic extrusion, polyamide 6, structure, thermal properties

Affiliations:
Skorupska M. - Institute of High Pressure Physics, Polish Academy of Sciences (PL)
Kulczyk M. - other affiliation
Denis P. - IPPT PAN
Grzęda D. - other affiliation
Czajka A. - other affiliation
Ryszkowska J. - other affiliation

Category A Plus

IPPT PAN

logo ippt            Pawińskiego 5B, 02-106 Warsaw
  +48 22 826 12 81 (central)
  +48 22 826 98 15
 

Find Us

mapka
© Institute of Fundamental Technological Research Polish Academy of Sciences 2024