Instytut Podstawowych Problemów Techniki
Polskiej Akademii Nauk


R. Litwinko

Ostatnie publikacje
1.  Oliferuk W., Maj M., Litwinko R., Urbański L., Thermomechanical coupling in the elastic regime and elasto-plastic transition during tension of austenitic steel, titanium and aluminium alloy at strain rates from 10-4 to 10-1 s-1, EUROPEAN JOURNAL OF MECHANICS A-SOLIDS, ISSN: 0997-7538, DOI: 10.1016/j.euromechsol.2011.08.007, Vol.35, pp.111-118, 2012

The temperature variation phenomenon during uniaxial deformation of materials with positive coefficient of linear thermal expansion is studied. The formula for a change in the specimen temperature during non-adiabatic tensile deformation is briefly derived. Thermomechanical behaviour of austenitic stainless steel, titanium and aluminium alloy during initial stage of tension at strain rates from 10−4 to 10−1 s−1 has been investigated. It was confirmed, that with increasing stress the temperature of each tested specimen first decreases linearly, reaches a minimum and then starts to rise. The decrease in the specimen temperature corresponds to elastic deformation whereas the temperature rise is related to the plastic one. Thus, the change in the specimen temperature can be used for study of elasto-plastic transition. From the viewpoint of strict theoretical analysis, the yield point will be defined as the stress corresponding to the lowest temperature, if tensile deformation process is adiabatic. The processes of deformation considered in this work are not adiabatic; there is a heat exchange between the specimen and the surroundings. The influence of this fact on the change in the specimen temperature vs. stress is discussed. The problem of yield point as the value of stress corresponding to minimum temperature of the specimen is considered. The influence of the strain rate on the yield point for tested materials is studied. Comparing of the obtained results with theoretical model, the limit above which the deformation process can be treated as the adiabatic one was determined. The values of the yield points determined on the basis of the thermoelastic effect were compared with the stress corresponding to the 0.2% of plastic strain.

Słowa kluczowe:
Thermoelastic effect, Yield point, Non-adiabatic deformation

Afiliacje autorów:
Oliferuk W. - IPPT PAN
Litwinko R. - inna afiliacja
Urbański L. - IPPT PAN
2.  Litwinko R., Oliferuk W., Yield point determination based on thermomechanical behaviour of polycrystalline material under uniaxial loading, ACTA MECHANICA ET AUTOMATICA, ISSN: 1898-4088, Vol.3, No.4, pp.1-3, 20096p.

Kategoria A Plus


logo ippt            ul. Pawińskiego 5B, 02-106 Warszawa
  +48 22 826 12 81 (centrala)
  +48 22 826 98 15

Znajdź nas

© Instytut Podstawowych Problemów Techniki Polskiej Akademii Nauk 2024