Instytut Podstawowych Problemów Techniki
Polskiej Akademii Nauk

Partnerzy

L.V. Malikov


Ostatnie publikacje
1.  Pogrebnjak A.D., Bratushka S.N., Uglov V., Rusakov V., Beresnev V.M., Anischik V., Malikov L.V., Levintant-Zayonts N., Structures and properties of Ti alloys after double implantation, VACUUM, ISSN: 0042-207X, DOI: 10.1016/j.vacuum.2009.01.072, Vol.83, No.Supplement 1, pp.S240-S244, 2009

Streszczenie:
The paper presents new results on investigation of structure and physical-mechanical properties of near surface layers of titanium alloys after (W+, Mo+) ion implantation and subsequent thermal annealing under 550 °C for 2 h. Using back scattering (RBS) of helium ions and protons, scanning electron microscopy (SEM) with microanalysis (EDS), (WDS), proton (ion) induced X-ray emission (PIXE), X-ray phase analysis (XRD) with a grazing incidence geometry (0.5° angle), measurements of nanohardness and elastic modulus, friction wear (cylinder-plate), measurements of corrosion resistance in a salt solution, we investigated the VT-6 samples, and determined their fatigue resistance under cyclic loads. Double increase of hardness, decrease of wear and increased fatigue resistance were found, which was related to the formation of small dispersion (nanodimension) nitride, carbonitride, and intermetalloid phases

Słowa kluczowe:
Implantation, Structure, Ti alloys, Composition, Hardness

Afiliacje autorów:
Pogrebnjak A.D. - Sumy State University (UA)
Bratushka S.N. - Sumy State University (UA)
Uglov V. - inna afiliacja
Rusakov V. - inna afiliacja
Beresnev V.M. - Charkowski Uniwersytet (UA)
Anischik V. - inna afiliacja
Malikov L.V. - inna afiliacja
Levintant-Zayonts N. - IPPT PAN
27p.
2.  Pogrebnjak A.D., Bratushka S.N., Malikov L.V., Levintant-Zayonts N., Erdybaeva N.K., Plotnikov S.V., Gritsenko B.P., Effect of high doses of N+, N+ + Ni+, and Mo+ + W+ ions on the physicomechanical properties of tini, TECHNICAL PHYSICS, ISSN: 1063-7842, DOI: 10.1134/S1063784209050107, Vol.54, No.5, pp.667-673, 2009

Streszczenie:
The surface layer of an equiatomic TiNi alloy, which exhibits the shape memory effect in the martensitic state, is modified with high-dose implantation of 65-keV N+ ions (the implantation dose is varied from 1017 to 1018 ions/cm2). TiNi samples are implanted by N+, Ni+-N+, and Mo+-W+ ions at a dose of 1017–1018 cm−2 and studied by Rutherford backscattering, scanning electron microscopy, energy dispersive spectroscopy, X-ray diffraction (glancing geometry), and by measuring the nanohardness and the elastic modulus. A Ni+ concentration peak is detected between two maxima in the depth profile of the N+ ion concentration. X-ray diffraction (glancing geometry) of TiNi samples implanted by Ni+ and N+ ions shows the formation of the TiNi (B2), TiN, and Ni3N phases. In the initial state, the elastic modulus of the samples is E = 56 GPa at a hardness of H = 2.13 ± 0.30 GPa (at a depth of 150 nm). After double implantation by Ni+-N+ and W+-Mo+ ions, the hardness of the TiNi samples is ∼2.78 ± 0.95 GPa at a depth of 150 nm and 4.95 ± 2.25 GPa at a depth of 50 nm; the elastic modulus is 59 GPa. Annealing of the samples at 550°C leads to an increase in the hardness to 4.44 ± 1.45 GPa and a sharp increase in the elastic modulus to 236 ± 39 GPa. A correlation between the elemental composition, microstructure, shape memory effect, and mechanical properties of the near-surface layer in TiNi is found.

Słowa kluczowe:
double ion implantation, nitinol, shape mempry effect, nanohardness, elastic modulus

Afiliacje autorów:
Pogrebnjak A.D. - Sumy State University (UA)
Bratushka S.N. - Sumy State University (UA)
Malikov L.V. - inna afiliacja
Levintant-Zayonts N. - IPPT PAN
Erdybaeva N.K. - Eastern-Kazakh State Technical University (RU)
Plotnikov S.V. - inna afiliacja
Gritsenko B.P. - inna afiliacja
13p.
3.  Pogrebnjak A.D., Bratushka S.N., Malikov L.V., Levintant-Zayonts N., Erdybaeva N.K., Plotnikov S.V., Gritsenko B.P., Wlijanije wysokich doz ionow N+, N++ Ni+, Mo++ W+ na fizikomechaniczeskije swojstwa TiNi, Журнал технической физики, ISSN: 0044-4642, Vol.79, No.5, pp.65-72, 2009

Streszczenie:
Поверхностный слой эквиатомного сплава TiNi, обладающего эффектом памяти формы в мартенситном состоянии, был модифицирован при помощи высокодозной имплантации ионов N+ с энергией 65keV (доза имплантации составила от 1017 до 1018 ion/cm2). С помощью методов резерфордовского обратного рассеяния ионов (RBS), растровой электронной микроскопии с микроанализом (SEM и EDS),метода XRD в скользящей геометрии, а также измерения нанотвердости и модуля упругости исследовались образцы TiNi после имплантации ионов N+,Ni+−N+,Mo+−W+ дозами от 1017 до ∼1018 cm−2. Между двумя максимумами концентрационного профиля ионов N+ обнаружен пик концентрацииионов Ni+. XRD-анализ в скользящей геометрии образцов TiNi после имплантации ионов Ni+ и N+ показал образование фаз TiNi(B2);TiN; Ni3N. Исследования механических характеристик образцов показали, что висходном состоянии модуль упругости образцов составлял E=56 GPa при твердости H=2.13±0.3 GPa (на глубине 150 nm). После двойной имплантации ионов Ni+−N+, W+−Mo+ твердость образцов TiNi на глубине 150 nm составляла∼2.78±0.95 GPa, а на глубине 50 nm ее значение возросло до 4.95±2.25 GPa при модуле упругости 59 GPa. Отжиг образцов при 550◦C привел к увеличению твердости до 4.44±1.45 GPa и резкому увеличению модуля упругости до значения 236±39 GPa. Обнаружена корреляция между элементным составом, микроструктурой, эффектом памяти формы и механическими свойствами приповерхностного слоя TiNi

Afiliacje autorów:
Pogrebnjak A.D. - Sumy State University (UA)
Bratushka S.N. - Sumy State University (UA)
Malikov L.V. - inna afiliacja
Levintant-Zayonts N. - IPPT PAN
Erdybaeva N.K. - Eastern-Kazakh State Technical University (RU)
Plotnikov S.V. - inna afiliacja
Gritsenko B.P. - inna afiliacja

Kategoria A Plus

IPPT PAN

logo ippt            ul. Pawińskiego 5B, 02-106 Warszawa
  +48 22 826 12 81 (centrala)
  +48 22 826 98 15
 

Znajdź nas

mapka
© Instytut Podstawowych Problemów Techniki Polskiej Akademii Nauk 2024